The effectiveness of iQprint® Wash will decrease over time as it becomes diluted with residual resin, however, it is possible to extend its life by passing it through a filter to remove any resin suspended in the wash material. You will need to replace the solution when you notice it becoming less effective at removing…

If you are experiencing a tacky finish on your printed models, it may be due to washing the model too long. However, the most common cause of a tacky finish on the printed models is not sufficiently rinsing the residual wash material from the model before curing. To ensure you get the best finish on…

The recommended washing time for printed models is 3-10 minutes. However, the washing time may vary depending on the type of cleaning unit you’re using. Propeller-driven wash units typically clean faster than ultra-sonic cleaning units. The washing time will also depend on the size and complexity of the model. Ensure that the model is completely…

iQprint® Wash is compatible with most wash units, but it is always best to check the manufacturer’s instructions before using it. Ensure that the wash unit is clean and free of any other chemicals.  

iQprint® Wash is a synthetic resin detergent, that is non-flammable, environmentally friendly, and safer to handle than isopropyl alcohol. However, as with any chemical product, it is recommended to handle the detergent with care, and to follow the instructions provided on the label. 

When handling the liquid, it is recommended that you wear gloves and safety goggles to protect your skin and eyes. Avoid contact with your eyes, skin, and clothing. 

iQprint® Wash is a 3D Printing Resin Detergent – the perfect solution for cleaning your 3D printed models. This powerful detergent is specially formulated to remove all traces of resin from your prints, leaving them looking clean and glossy.